Applying Vinyl Wet

 

Your decal will come supplied in 3 parts.

 

1.  The top layer is the application tape.

 

2.  The middle layer is the vinyl decal.

 

3.  The bottom layer is the backing paper.

 

Wet application fluid:  You can make your own application fluid with 4 drops of dishwashing liquid to 1 quart of water in a spray bottle.

 

 

 

Wash and rinse the area.  Then dry the

surface with a clean, lint-free towel or cloth.

Measure and mark where you want your decal to be placed.

Spray the surface with the wet application fluid.

 Place your vinyl decal on a flat surface and carefully remove the 

backing paper.  You may also choose to spray the back of the 

vinyl at this point to prevent them accidentally sticking together.

  

Place your decal on the surface and move around until it's correctly

lined up.  You may lift and move your decal around for as long as it's

wet.

Using your squeegee (or any other flat, smooth edge such as a

credit card or ruler), apply pressure from the middle outwards.  This

will remove all water and the decal will stick.  

  

The time it takes tostick will depend on the temperature.  If it very

cold it can take hours,  but usually it will take around 15-30 minutes.

  

Gently pull back the application tape.  If the vinyl begins to lift, then

lay it back down and squeegee some more.  Wait a little bit longer

for it to stick and try again.   

  
 Finished job!!